Company History
|
Quality Policy
|
Vision and Mission
|
Technology
|
Factory Introduction
|
News and Press Releases |
Brands
Electroplating Rectifiers
Electroplating Rectifiers are used direct current source on areas like purification of metals,chemical raw material production etc…They can be produced in different current and voltage values depending on the material which would be electroplated. Since the electroplating is a long and high power needed process the rectifiers used for this process should be designed to run 7/24 with high power coefficiency and yield.
Either thyristor controlled systems or switch mode systems could be used in electroplating rectifiers. Depending on the capacity of the rectifier air cooled or water cooled can be chosen. In some applications rectifier capacity may reach over 1MW. In these applications high voltage feeded rectifiers are used. MRS Electrical Appliances have realized rectifier production whose power change from 100 kW up to 3000 kW.
New AC Drive Unit
MRSPlating rectifiers are equipped with new AC power control unit which reduces the rectifier malfunctions and increases the rectifier yield and functions.With the new AC drive unit the malfunctions are avoided before they occur .So that it can be used under the hardest circumstances. The new Control Unit has the ability to work manually and with automation system at the same time. Additional features are also available to be made over time in addition to large number of features.
Timer
The timer on the running program allows to adjust running on a definite period of time or indefinite period of time. On definite time running the rectifier works during desired period of time then stops and gives a signal to warn the operator at the end of process. On indefinite working program the rectifier works untill it is stopped manually.
Amperehour and Autodosing
MRS plating rectifiers have amperehour calculation feature which ensures the most reliable information about the complete working time of the bath.The plating process can be adjusted on amperehour basis instead of time values.There are different counters on the operator panel for current plating process and all other processes which can be also used for adding chemicals to pool. Especially in critical baths chemical concentration control is extremely important. MRS rectifiers help you chemical control as well as giving data for the entire working and yield of the system.
Selective Working Program
In most of the plating pools selective working program is used to remove undesired metals from the pool. But this process is made manually or by an external device. In MRS plating rectifiers this is done automatically with this selective working program. After the process starts, the output voltage is increased from zero and turns to zero again periodically. This process is repeated by definetely or indefinetely. In such way the selective working is done easily which is a very hard maintenance process.
.
Easy to use
MRS Standard Plating rectifiers have a very sipmle running program. With the remote control unit the operator can run the device without going near to it. The system is fully compatible with all automation systems which also can work either manually or with automation system together.
Profibus DP Metal purification procedures
Gold, Silver production of precious metals, etc.
Production of chemical substances
Chlorine production
Hypochlorite Generation
Disinfect the water
|