AmpereHour
Professional chemical consumption of coating processes, coating thickness, and so on. ampere-hour value of transactions is an important control given the data into the bathroom. Considering this need, rectifiers MRS software provides programmable ampere-hour feature. Ampere-hour ampere-minute feature of the device according to the current value of the ampere-seconds, or can be set to work. Ampere-hour value of the current and the total is kept in two different ways. Actual ampere-hour value of the device for a specific process begins the moment the device to stop processing until the end of the current applied to the bathroom last time period multiplied by the number of hours of time. 30 minutes in the bathroom during the actual implementation of current 4000A 4000A x ½ h = 2000 ampere-hour value will be Ah. Other ampere-hour meter is used for the total ampere-hours. Total ampere-hour value of the unit values of each study period the overall sum of the actual amp-hours. To continue the example above, the device 10 times a day trying to imagine a half-hour periods. In this case, the total value of ampere-hours will be 2000Ah x 10 = 20000Ah. Ampere-hour meters can be used to schedule automatic dosing can also be used to maintain the balance of the chemical bath. If the device is used for timing the start of the study and then calculates the actual value of the ampere-hour ampere-hour ampere-hour value reaches the set value automatically stops. Warning signal, the device will be operated using the system. Dosing for the actual signal, or the total ampere-hour meters available. Actual ampere hour ampere-hour value has been obtained using the value set in the device gives a warning signal for a period of 10 seconds. This warning signal can be run using the automatic dosing system. Warning signals can also be set to the value of the total ampere-hours. In this case, the value set the value of the total ampere-hours after the device gives warning. Common pool fed by a chemical preparation plant located in more than one bathroom, all the warning signal of a device produced by MRS may be an external unit, the number of ampere-hours. In this case, the sum of the external unit receives signals from other devices and gives a warning signal to the desired value is reached. Thus, a fully automated system would be established. Devices with low current value of the counter can be set in minutes or seconds. Thus, a more precise control can be achieved. |